Preloader
 Registered Address : No 14, Kunnan Street, Kattoor, Coimbatore 641009.

Loctite 574 Gasketing products

Directions for use:

1. For best performance bond surfaces should be clean and free from grease.

2. The product is designed for close fitting flanged parts with gaps up to 0.25 mm ( in).

3. Apply manually as a continuous bead, a rolled film or by screen printing to one surface of the flanges. For gaps greater than 0.125mm (0.005 in) using a pen roller, a rolled film should be applied to both flange surfaces.

4. Low pressures (<0.5 MPa, psi) may be used when testing to confirm a complete seal immediately after assembly and before curing.

5. Flanges should be tightened as soon as possible after assembly to avoid shimming.

Enquiry Now

LOCTITE® 574 seals close-fitting joints between inflexible metallic faces and flanges. The product therapies when restricted in the absence of air between close-fitting steel surfaces. It presents resistance to low pressures right now after assembly. Typically used as a form-in-place gasket on inflexible flanged connections. The nature of LOCTITE 574 reduces the migration of liquid product after utility to the substrate. It has a excessive oil tolerance and terrific water and glycol resistance.

Customer Reviews
//