Direction for use : For Assembly
1. For best results, clean all surfaces (external and internal) with a LOCTITE® cleaning solvent and allow to dry.
2. If the material is an inactive metal or the cure speed is too slow, spray with LOCTITE® SF 7471™ or LOCTITE® SF 7649™ and allow to dry.
3. Apply a 360° bead of product to the leading threads of the male fitting, leaving the first thread free. Force the material into the threads to thoroughly fill the voids. For bigger threads and voids, adjust product amount accordingly and apply a 360° bead of product on the female threads also.
4. Using compliant practices, assemble and wrench tighten fittings in accordance with manufacturers recommendations.
5. Properly tightened fittings will seal instantly to moderate pressures. For maximum pressure resistance and solvent resistance allow the product to cure a minimum of 24hours.
LOCTITE® 567 is an off-white, low strength, thixotropic methacrylate thread sealant. It treatment plans in the absence of air and through contact with metals when restricted inside threads up to M80/R3”. It is quality perfect for use on coarse metallic threads and its breakaway torque ranking is 1.7Nm. Viscosity is 280,000 – 800,000 mPa·s and carrier temperature -55 to +200ºC. UL approved.
